B2273 Ignition 2 Monitor Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when a malfunction occurs in the IG2D output circuit, which is between the integration relay (IG2 relay) actuation circuit inside the main body ECU and the integration relay (IG2 relay).| DTC Code |
Detection Condition |
Trouble Area |
| B2273 |
The integration relay (IG2 relay) actuation circuit inside the main body ECU or other related circuit is malfunctioning. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (IG2 RELAY MONITOR (INSIDE)) |
Use the Data List to check if the integration relay (IG2 relay) is functioning properly.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
IG2 Relay Monitor (Inside)
Integration relay (IG2 relay) inner relay monitor/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
- OK:
- When the engine switch is turned on (IG), ON is displayed on the tester.
|
|
||||
| OK | |
| 2. CHECK WHETHER DTC OUTPUT RECURS |
Clear the DTCs (Click here).
Turn the engine switch on (IG), wait at least 10 seconds, and check whether DTC B2273 is output.
Result Result
Proceed to
No DTC output
A
DTC B2273 output
B
|
|
||||
| A | ||
| ||
| 3. INSPECT FUSE (IG2 MAIN) |
Remove the IG2 MAIN fuse from the integration relay.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
IG2 MAIN fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT INTEGRATION NO.1 RELAY (IG2 RELAY) |
![]() ![]() |
Install the IG2 MAIN fuse to the integration relay.
Remove the integration relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1B-8 - 1C-1
Battery voltage applied to terminals 1B-6 and 1B-7
Below 1 Ω
1B-8 - 1C-1
Battery voltage not applied to terminals 1B-6 and 1B-7
10 kΩ or higher
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - INTEGRATION RELAY (IG2 RELAY) AND BODY GROUND) |


Disconnect the E2 main body ECU connector.
Disconnect the 1B integration relay connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E2-11 (IG2D) - 1B-6
Always
Below 1 Ω
1B-7 - Body ground
Always
Below 1 Ω
E2-11 (IG2D) or 1B-6 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||

