B2274 ACC Monitor Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when a malfunction occurs in the ACCD output circuit, which is between the ACC relay actuation circuit inside the main body ECU and the ACC relay.| DTC Code |
Detection Condition |
Trouble Area |
| B2274 |
The ACC relay actuation circuit inside the main body ECU or other related circuit is malfunctioning. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (ACC RELAY MONITOR) |
Use the Data List to check if the ACC relay is functioning properly.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ACC Relay Monitor
ACC relay monitor/ON or OFF
ON: Engine switch on (IG)
OFF: Engine switch off
-
- OK:
- When the engine switch is turned on (IG), ON is displayed on the intelligent tester.
|
|
||||
| OK | |
| 2. CHECK WHETHER DTC OUTPUT RECURS |
Clear the DTCs (Click here).
Turn the engine switch on (IG), wait at least 10 seconds, and check whether DTC B2274 is output.
Result Result
Proceed to
No DTC output
A
DTC B2274 output
B
|
|
||||
| A | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND) |


Disconnect the E1, 2A and 2D main body ECU connectors.
Measure the voltage and resistance according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
2A-1 - Body ground
Always
11 to 14 V
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E1-22 (ACCD) - 2D-45
Always
Below 1 Ω
2D-62 (GND2) - Body ground
Always
Below 1 Ω
E1-22 (ACCD) or 2D-45 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
