2011-2013 Land Cruiser · Service Manual Steering

IG Power Source Circuit

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU.
The multiplex tilt and telescopic ECU also receives engine switch signals via this circuit.

WIRING DIAGRAM

C149010E02

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG1 No. 1)
  1. Remove the ECU-IG1 No. 1 fuse from the main body ECU.

  1. Measure the resistance of the fuse.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG1 No. 1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK MULTIPLEX TILT AND TELESCOPIC ECU (IG TERMINAL VOLTAGE)

  1. C149087E23
    Disconnect the E27 connector from the multiplex tilt and telescopic ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E27-8 (IG) - E27-11 (GND)
    Engine switch on (IG)
    11 to 14 V



NG
Go to step 3
OK

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)

3. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)

  1. C149087E22
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E27-11 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - MAIN BODY ECU)
C175814E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    2D-56 - Body ground
    Engine switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (MAIN BODY ECU - BATTERY)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - MAIN BODY ECU)


← Tilt and Telescopic Manual Switch Circuit (from Sep 2011)PRECAUTION (from Sep 2011) →