2011-2013 Land Cruiser · Service Manual Steering

B2620 ECU Power Source Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Sep 2011

DESCRIPTION

The ECU power source circuit supplies positive voltage to the multiplex tilt and telescopic ECU.
DTC Code
Detection Condition
Trouble Area
B2620
The ECU power source voltage drops to 8 V or less and this condition continues for 10 sec. or more.
  1. ECU-B1 fuse
  2. Harness or connector
  3. Multiplex tilt and telescopic ECU

WIRING DIAGRAM

C149263E05

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-B1)
  1. Remove the ECU-B1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-B1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)

  1. C149087E24
    Disconnect the E27 multiplex tilt and telescopic ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E27-9 (ECUB) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)

  1. C149087E22
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E27-11 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)


← B2611 Telescopic Position Sensor or Telescopic Motor Circuit Malfunction (from Sep 2011)B2621 Communication Interruption (Sep 2011 – Dec 2011) →