2011-2013 Land Cruiser · Service Manual Steering

Actuator Power Source Circuit

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

This is the power source for the motors.

WIRING DIAGRAM

C149263E03

INSPECTION PROCEDURE


1. INSPECT FUSE (TI & TE)
  1. Remove the TI & TE fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    TI & TE fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)

  1. C149087E21
    Disconnect the E27 multiplex tilt and telescopic ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E27-2 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)

  1. C149087E22
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E27-11 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

CHECK IG POWER SOURCE CIRCUIT (Click here)


← B2624 Vehicles Speed Malfunction (from Jan 2012)Tilt and Telescopic Manual Switch Circuit (from Sep 2011) →