Troubleshooting · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
HINT:
Use the following procedures to troubleshoot the seat belt warning system.
*: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
NEXT
3.CHECK FOR DTC*
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Based on the DTCs output above, try to cause the output of the same CAN communication system DTC or airbag system DTC by simulating the symptoms indicated by the DTC. Then recheck for DTCs.