2011-2013 Land Cruiser · Service Manual Vehicle Interior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the following procedures to troubleshoot the seat belt warning system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
    NEXT

    3.CHECK FOR DTC*
    1. Check for DTCs and make a note of any codes that are output.

    2. Clear the DTCs.

    3. Based on the DTCs output above, try to cause the output of the same CAN communication system DTC or airbag system DTC by simulating the symptoms indicated by the DTC. Then recheck for DTCs.

      Result 
      Result
      Proceed to
      DTC is not output
      A
      CAN communication system DTC is output (for LHD)
      B
      CAN communication system DTC is output (for RHD)
      C
      Airbag system DTC is output
      D


    B.

    C.

    D.
    A

    4.PROBLEM SYMPTOMS TABLE
    1. Refer to the problem symptoms table (Click here).

    NEXT

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation check (Click here)

    2. Data List / Active Test (Click here)

    3. Terminals of ECU (Click here)

    NEXT

    6.REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)OPERATION CHECK (Sep 2011 – Dec 2011) →