2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Jam Protection Function does not Operate

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

  1. This symptom may occur to all door windows.
    The jam protection function operates within a specified range during the manual up or auto up operation.

INSPECTION PROCEDURE


1. PERFORM INITIALIZATION
  1. Initialize the power window regulator motor (Click here).

  1. Check if the power window auto up/down function operates (Click here).

    OK:
    Auto up/down function operates.



NG
END (PROBLEM DUE TO INITIALIZATION FAILURE)
OK


2. CHECK JAM PROTECTION FUNCTION OPERATING RANGE
  1. Check if the jam protection function operates for applicable power window.

    HINT:
    The jam protection function does not operate from the fully closed position of the door glass to 4 mm (0.157 in.) below that.

    OK:
    Jam protection function operates.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD)
    B
    NG (for RHD)
    C



B
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)

C
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)
A

END


← Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) (from Jan 2012)Jam Protection Function does not Operate (from Jan 2012) →