B2286 Runnable Signal Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The main body ECU and ECM are connected by a cable and the CAN communication line. If the cable information and CAN information are inconsistent, this DTC is stored.| DTC Code |
Detection Condition |
Trouble Area |
| B2286 |
The cable and CAN information between the main body ECU and ECM is inconsistent. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (ENGINE CONDITION) |
Use the Data List to check if the engine start is functioning properly.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Engine Condition
Engine condition/RUN or STOP
RUN: Engine running
STOP: Engine stopped
-
Result Result
Proceed to
Display on the intelligent tester does not change according to engine condition
A
Display on the intelligent tester changes according to engine condition
B
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |


Disconnect the E3 main body ECU connector.
Disconnect the A38 (for LHD) or A52 (for RHD) ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E3-8 (TACH) - A38-15 (TACH)*1
E3-8 (TACH) - A52-15 (TACH)*2
Always
Below 1 Ω
E3-8 (TACH) or A38-15 (TACH) - Body ground*1
E3-8 (TACH) or A52-15 (TACH) - Body ground*2
Always
10 kΩ or higher
- HINT:
- *1: for LHD
- *2: for RHD
|
|
||||
| OK | |
| 3. REPLACE MAIN BODY ECU |
Temporarily replace the main body ECU with a new or normally functioning one.
Check whether DTC B2286 is output.
Result Result
Proceed to
DTC not output
A
DTC output (for 1GR-FE)
B
DTC output (for 1UR-FE)
C
DTC output (for 3UR-FE)
D
DTC output (for 1VD-FTV)
E
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
