2011-2013 Land Cruiser · Service Manual Steering

C1592/52 Actuator Neutral Position Calibration Incomplete

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The steering control ECU first checks the actuator angle neutral position calibration flag after entering test mode. If the ECU detects that steering actuator angle neutral position calibration is incomplete twice, it will store DTC C1592/52.
DTC Code
DTC Detection Condition
Trouble Area
C1592/52
The steering control ECU detects that steering actuator angle neutral position calibration is incomplete twice.
  1. Steering actuator
  2. Steering control ECU

INSPECTION PROCEDURE


1. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2. PERFORM VGRS SYSTEM CALIBRATION
  1. Perform VGRS system calibration (Click here).


NEXT


3. CHECK DTC
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    C1592/52 is output after VGRS system calibration has been performed 3 times or more
    A
    C15B2/72 is output (for LHD)
    B
    C15B2/72 is output ( for RHD)
    C
    DTC is not output
    D

    NOTICE:
    If DTC C1592/52 is output even though the VGRS system calibration has been performed, confirm the procedure again, and perform the VGRS system calibration 3 times or more.



B
REPLACE STEERING CONTROL ECU (Click here)

C
REPLACE STEERING CONTROL ECU (Click here)

D
END
A

REPLACE STEERING ACTUATOR ASSEMBLY (Click here)


← C1592/52 Actuator Neutral Position Calibration Incomplete (Sep 2011 – Dec 2011)C1593/53 Actuator Standard Position Malfunction (Sep 2011 – Dec 2011) →