2011-2013 Land Cruiser · Service Manual Steering

C15C3/75 Brake System Control Module Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The steering control ECU detects a vehicle speed error by receiving an error signal from the skid control ECU via CAN communication.
If the steering control ECU detects this error signal, it will turn the master warning light on, store this DTC, and stop VGRS operation.
DTC Code
DTC Detection Condition
Trouble Area
C15C3/75
The steering control ECU receives a vehicle speed error signal via CAN communication.
  1. Vehicle stability control system
  2. CAN communication system
  3. Steering control ECU

INSPECTION PROCEDURE


1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for DTCs in the vehicle stability control system (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    OK
    DTC is output
    NG



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
OK


2. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Using the intelligent tester, check if the CAN communication system is functioning normally (Click here for LHD, Click here for RHD).

    Result 
    Result
    Proceed to
    DTC is not output (for LHD)
    A
    DTC is not output (for RHD)
    B
    DTC is output (for LHD)
    C
    DTC is output (for RHD)
    D



B
REPLACE STEERING CONTROL ECU (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A

REPLACE STEERING CONTROL ECU (Click here)


← C15C1/74 Steering Angle Sensor Malfunction (+ C15C2/74) (from Jan 2012)C15C3/75 Brake System Control Module Malfunction (from Jan 2012) →