2011-2013 Land Cruiser · Service Manual Steering

C15C6/77 IG Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The steering control ECU monitors the IG power supply voltage.
If the steering control ECU detects a malfunction, it will turn on the master warning light, store DTC C15C6/77, and stop VGRS operation.
DTC Code
DTC Detection Condition
Trouble Area
C15C6/77
The steering control ECU detects that the battery voltage is normal and the IG terminal voltage is below 4 V for 6 seconds.
  1. Harness or connector
  2. Steering control ECU

WIRING DIAGRAM

C151230E04

INSPECTION PROCEDURE

HINT:
The fault may be intermittent. Check the harnesses and connectors thoroughly and retest.


1. CHECK STEERING CONTROL ECU (POWER SOURCE CIRCUIT)
  1. Record and clear the DTCs (Click here).

  1. C149134E12
    Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E77-7 (PGND) - Body ground
    Always
    Below 1 Ω
    E78-8 (PGD2) - Body ground

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E77-3 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. RECONFIRM DTC OUTPUT
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    C15C6/77 is not output
    A
    C15C6/77 is output (for LHD)
    B
    C15C6/77 is output (for RHD)
    C



B
REPLACE STEERING CONTROL ECU (Click here)

C
REPLACE STEERING CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C15C3/75 Brake System Control Module Malfunction (from Jan 2012)C15C6/77 IG Power Supply Voltage Malfunction (from Jan 2012) →