C15C7/78 DC Motor Power Source Voltage Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Also covers:
- C15C8/79 Power Supply Relay Failure
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The steering control ECU monitors PIG (motor power source voltage) and detects a malfunction in the power supply relay (located inside the steering control ECU).If the steering control ECU detects a malfunction, it will turn on the master warning light, store these DTCs, and stop VGRS operation.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C15C7/78 |
The steering control ECU detects that the IG terminal voltage is between 9 and 16 V, and the PIG terminal voltage is below 7 V or higher than 18.5 V for 2.4 seconds. |
|
| C15C8/79 |
The steering control ECU detects a malfunction in the power source relay or an open circuit. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- The fault may be intermittent. Check the harnesses and connectors thoroughly and retest.
| 1. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
Record and clear the DTCs (Click here).
Measure the resistance and voltage according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
E77-7 (PGND) - Body ground
Always
Below 1 Ω
E78-8 (PGD2) - Body ground
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E77-8 (PIG) - Body ground
Always
11 to 14 V
|
|
||||
| OK | |
| 2. RECONFIRM DTC OUTPUT |
Check for DTCs (Click here).
Result Result
Proceed to
C15C7/78 or C15C8/79 is not output
A
C15C7/78 or C15C8/79 is output (for LHD)
B
C15C7/78 or C15C8/79 is output (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
