2011-2013 Land Cruiser · Service Manual Steering

C15C7/78 DC Motor Power Source Voltage Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

Also covers:

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The steering control ECU monitors PIG (motor power source voltage) and detects a malfunction in the power supply relay (located inside the steering control ECU).
If the steering control ECU detects a malfunction, it will turn on the master warning light, store these DTCs, and stop VGRS operation.
DTC Code
DTC Detection Condition
Trouble Area
C15C7/78
The steering control ECU detects that the IG terminal voltage is between 9 and 16 V, and the PIG terminal voltage is below 7 V or higher than 18.5 V for 2.4 seconds.
  1. Harness or connector
  2. Steering control ECU
C15C8/79
The steering control ECU detects a malfunction in the power source relay or an open circuit.
  1. Harness or connector
  2. Steering control ECU

WIRING DIAGRAM

C167706E03

INSPECTION PROCEDURE

HINT:
The fault may be intermittent. Check the harnesses and connectors thoroughly and retest.


1. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
  1. Record and clear the DTCs (Click here).

  1. C149134E13
    Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E77-7 (PGND) - Body ground
    Always
    Below 1 Ω
    E78-8 (PGD2) - Body ground

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E77-8 (PIG) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. RECONFIRM DTC OUTPUT
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    C15C7/78 or C15C8/79 is not output
    A
    C15C7/78 or C15C8/79 is output (for LHD)
    B
    C15C7/78 or C15C8/79 is output (for RHD)
    C



B
REPLACE STEERING CONTROL ECU (Click here)

C
REPLACE STEERING CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C15C7/78 DC Motor Power Source Voltage Malfunction (+ C15C8/79) (Sep 2011 – Dec 2011)U0100/56 Lost Communication with ECM / PCM "A" (+ U0122/56, U0126/56) (Sep 2011 – Dec 2011) →