B2624 Vehicles Speed Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the communication bus on a regular schedule. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the communication bus to prevent improper operation of the auto away/return function during driving.| DTC Code |
Detection Condition |
Trouble Area |
| B2624 |
|
|
- HINT:
- *: If the engine switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).
INSPECTION PROCEDURE
| 1. CHECK OTHER DTC OUTPUT |
Check if DTC B2621 is output (Click here).
Result Result
Proceed to
B2621 is not output
A
B2621 is output
B
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (SPEED SIGNAL) |
Use the Data List to check if the speed signal is functioning properly.
Tilt & Telescopic Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Freeze Speed Info
Vehicle speed data/min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
Actual vehicle speed
-
| Result |
Proceed to |
| Tester indication is normal |
A |
| Tester indication is abnormal |
B |
- HINT:
- A vehicle speed of 3 km/h (2 mph) or more may be displayed on the intelligent tester screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal input via the communication bus and is not a malfunction.
|
|
||||
| A | ||
| ||
