2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

CD Sound Skips

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

INSPECTION PROCEDURE


1. CLEAN CD

  1. I100151
    If the disc is dirty, clean the disc by wiping the CD underside radially with a soft cloth.

    OK:
    Malfunction disappears.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.



NG
Go to step 2
OK

CD WAS DIRTY

2. REPLACE CD WITH ANOTHER AND RECHECK
  1. Replace the CD with a normal one and check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
Go to step 3
OK

CD IS FAULTY

3. CHECK WHEN PROBLEM OCCURS
  1. Check the location in which CD skipping occurs.

    Result 
    Result
    Proceed to
    Driving surface is bumpy or rough
    A
    Driving surface is normal
    B



B
Go to step 5
A


4. CHECK RADIO RECEIVER INSTALLATION
  1. Check the installation condition of the radio receiver.

    OK:
    Installed properly.



NG
INSTALL RADIO RECEIVER PROPERLY (Click here)
OK


5. INSTALL RADIO RECEIVER IN ANOTHER VEHICLE OF SAME MODEL AND COMPARE
  1. Remove the radio receiver and install it in another vehicle of the same model. Check if the CD sound skips.

    OK:
    CD sound does not skip.



NG
Go to step 6
OK

MALFUNCTIONS MAY NOT BE PRESENT

6. DID TEMPERATURE IN CABIN CHANGE RAPIDLY?
  1. Check whether or not a rapid temperature change occurred in the cabin.

    OK:
    Rapid temperature change occurred.

    HINT:
    A rapid temperature change creates condensation inside the CD player, which may disable CD playback.



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK

CONDENSATION DUE TO TEMPERATURE CHANGE (LEAVE AS IS FOR A WHILE BEFORE USING)


← CD Sound Skips (Sep 2011 – Dec 2011)Radio Broadcast cannot be Received (Bad Reception) (Sep 2011 – Dec 2011) →