Navigation ECU Power Source Circuit
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
This is the power source circuit to operate the display and navigation module display.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY POWER SOURCE) |
Disconnect the F64 display and navigation module display connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F64-10 (GND1) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
F64-1 (+B1) - F64-10 (GND1)
Always
11 to 14 V
F64-2 (ACC) - F64-10 (GND1)
Engine switch on (ACC)
11 to 14 V
F64-3 (IG) - F64-10 (GND1)
Engine switch on (IG)
11 to 14 V
Text in Illustration *1
Front view of wire harness connector
(to Display and Navigation Module Display)
|
|
||||
| OK | ||
| ||
