Check for continuity at the center of each antenna wire as shown in the illustration.
NOTICE:
When cleaning the glass, wipe it in the direction of the wire with a soft dry cloth. Take care not to damage the wire. Do not use detergents or glass cleaners with abrasive ingredients. When measuring resistance, wrap a piece of tin foil around the tip of each probe and press the foil against the wire with your finger, as shown in the illustration.
OK:
There is continuity in the antenna.
NG
REPAIR GLASS ANTENNA
OK
5. INSPECT RADIO RECEIVER ASSEMBLY
Disconnect the RA radio receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
RA-5 (ANT+) - Body ground
Engine switch on (ACC) Radio switch on
11 to 14 V
Text in Illustration
*1
Component without harness connected (Radio Receiver Assembly)