2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Navigation ECU and Multi-media Interface ECU

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This is the sound signal circuit from the multi-media interface ECU to the display and navigation module display.

WIRING DIAGRAM

E192464E05

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NAVIGATION ECU)
  1. Disconnect the L41 multi-media interface ECU connector.

  1. Disconnect the F61 display and navigation module display connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L41-2 (URO+) - F61-3 (VAR+)
    Always
    Below 1 Ω
    L41-3 (ULO+) - F61-4 (VAL+)
    L41-4 (UGD1) - F61-7 (VA-)
    L41-1 (USD1) - F61-1 (AGND)
    L41-2 (URO+) - Body ground
    Always
    10 kΩ or higher
    L41-3 (ULO+) - Body ground
    L41-4 (UGD1) - Body ground
    L41-1 (USD1) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound from Wired Headphones is Difficult to Hear, cannot be Heard, or Quality is Poor (from Jan 2012)Sound Signal Circuit between Headphone Terminal and Television Display (Sep 2011 – Dec 2011) →