2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Headphone Terminal and Television Display

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This is the sound signal circuit from the television display assembly to the headphone terminal.

WIRING DIAGRAM

E192463E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY - HEADPHONE TERMINAL)
  1. Disconnect the L39 television display assembly connector.

  1. Disconnect the P1 headphone terminal connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L39-20 (HP2R) - P1-1 (HP2R)
    Always
    Below 1 Ω
    L39-18 (HP2L) - P1-2 (HP2L)
    Always
    Below 1 Ω
    L39-19 (SLD2) - P1-3 (SGN2)
    Always
    Below 1 Ω
    L39-17 (HP1R) - P1-9 (HP1R)
    Always
    Below 1 Ω
    L39-15 (HP1L) - P1-10 (HP1L)
    Always
    Below 1 Ω
    L39-16 (SLD1) - P1-11 (SGN1)
    Always
    Below 1 Ω
    L39-20 (HP2R) - Body ground
    Always
    10 kΩ or higher
    L39-18 (HP2L) - Body ground
    Always
    10 kΩ or higher
    L39-19 (SLD2) - Body ground
    Always
    10 kΩ or higher
    L39-17 (HP1R) - Body ground
    Always
    10 kΩ or higher
    L39-15 (HP1L) - Body ground
    Always
    10 kΩ or higher
    L39-16 (SLD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Navigation ECU and Multi-media Interface ECU (Sep 2011 – Dec 2011)Sound Signal Circuit between Headphone Terminal and Television Display (from Jan 2012) →