2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Radio Receiver and Video Terminal

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This is the sound signal circuit from the video terminal to the multi-media module receiver assembly.

WIRING DIAGRAM

E251473E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - VIDEO TERMINAL)
  1. Disconnect the F78 multi-media module receiver assembly connector.

  1. Disconnect the P1 headphone terminal (video terminal) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F78-7 (VAR+) - P1-5 (VAR+)
    Always
    Below 1 Ω
    F78-8 (VAL+) - P1-6 (VAL+)
    Always
    Below 1 Ω
    F78-15 (VA-) - P1-7 (VA-)
    Always
    Below 1 Ω
    F78-5 (AGND) - P1-15 (SG)
    Always
    Below 1 Ω
    F78-7 (VAR+) - Body ground
    Always
    10 kΩ or higher
    F78-8 (VAL+) - Body ground
    Always
    10 kΩ or higher
    F78-15 (VA-) - Body ground
    Always
    10 kΩ or higher
    F78-5 (AGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Multi-media Interface ECU and Video Terminal (Sep 2011 – Dec 2011)Visual Mute Signal Circuit between Navigation ECU and Television Display (Sep 2011 – Dec 2011) →