2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Visual Mute Signal Circuit between Navigation ECU and Television Display

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This is the visual mute signal circuit from the display and navigation module display to the television display assembly.

WIRING DIAGRAM

E182539E07

INSPECTION PROCEDURE


1. INSPECT DISPLAY AND NAVIGATION MODULE DISPLAY

  1. E184847E03
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F65-4 (VMTR) - Body ground
    RSE is playing → Source is changed
    4 V or higher → Below 0.7 V → 4 V or higher

    Text in Illustration 
    *1
    Component with harness connected
    (Display and Navigation Module Display)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - TELEVISION DISPLAY)
  1. Disconnect the F65 display and navigation module display connector.

  1. Disconnect the L39 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F65-4 (VMTR) - L39-9 (VMTR)
    Always
    Below 1 Ω
    F65-4 (VMTR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT DISPLAY AND NAVIGATION MODULE DISPLAY
  1. Reconnect the F65 display and navigation module display connector.

  1. E192430E07
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L39-9 (VMTR) - Body ground
    Display is operating
    4 V or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Television Display Assembly)



NG
REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)
OK

REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)


← Sound Signal Circuit between Radio Receiver and Video Terminal (from Jan 2012)Visual Mute Signal Circuit between Radio Receiver and Television Display (from Jan 2012) →