2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Multi-media Interface ECU and Video Terminal

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This is the sound signal circuit from the video terminal to the multi-media interface ECU.

WIRING DIAGRAM

E192464E06

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (VIDEO TERMINAL - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the P1 video terminal connector.

  1. Disconnect the L42 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    P1-5 (VAR+) - L42-1 (VRI)
    Always
    Below 1 Ω
    P1-6 (VAL+) - L42-9 (VLI)
    Always
    Below 1 Ω
    P1-7 (VA-) - L42-10 (VGN)
    Always
    Below 1 Ω
    P1-15 (SG) - L42-2 (SGND)
    Always
    Below 1 Ω
    P1-5 (VAR+) - Body ground
    Always
    10 kΩ or higher
    P1-6 (VAL+) - Body ground
    Always
    10 kΩ or higher
    P1-7 (VA-) - Body ground
    Always
    10 kΩ or higher
    P1-15 (SG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Navigation ECU and Video Terminal (Sep 2011 – Dec 2011)Sound Signal Circuit between Radio Receiver and Video Terminal (from Jan 2012) →