2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

B15C2 Speed Signal Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The display and navigation module display receives a vehicle speed signal from the combination meter assembly and information about the GPS antenna, and then adjusts vehicle position.
The display and navigation module display stores this DTC when the difference between the speed information that the GPS antenna receives and the SPD pulse received from the combination meter assembly becomes large.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.

DTC No.
DTC Detection Condition
Trouble Area
B15C2
A difference between the GPS speed and SPD pulse is detected.
  1. Combination meter assembly
  2. Wire harness or connector
  3. Display and navigation module display

WIRING DIAGRAM

E194845E06

INSPECTION PROCEDURE


1. CHECK VEHICLE SENSOR (OPERATION CHECK)

  1. E176549
    Enter the "Vehicle Sensors" screen. Refer to check GPS & Vehicle Sensors in Operation Check (Click here).

  1. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.



NG
Go to step 2
OK

REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)

2. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM)

  1. E194879E01
    Check the input waveform.
    1. Remove the combination meter assembly with the connector(s) still connected.

    2. Connect an oscilloscope to terminal E7-4 (+S) and body ground.

    3. Turn the engine switch on (IG).

    4. Turn the wheel slowly.

    5. Check the signal waveform according to the condition(s) in the table below.

      Item
      Condition
      Measurement terminal
      E7-4 (+S) - Body ground
      Tool setting
      5 V/DIV., 20 ms./DIV.
      Vehicle condition
      Driving at approx. 20 km/h (12 mph)
      Text in Illustration 
      *1
      Component with harness connected
      (Combination Meter Assembly)

      OK:
      The waveform is displayed as shown in the illustration.

      HINT:
      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY - COMBINATION METER)
  1. Disconnect the F64 display and navigation module display connector.

  1. Disconnect the E7 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F64-18 (SPD) - E7-4 (+S)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)


← B15C0 Short in GPS Antenna (+ B15C1) (Sep 2011 – Dec 2011)B15D0 MOST Communication Malfunction (Sep 2011 – Dec 2011) →