B15C2 Speed Signal Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
The display and navigation module display receives a vehicle speed signal from the combination meter assembly and information about the GPS antenna, and then adjusts vehicle position.The display and navigation module display stores this DTC when the difference between the speed information that the GPS antenna receives and the SPD pulse received from the combination meter assembly becomes large.
- HINT:
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
- If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B15C2 |
A difference between the GPS speed and SPD pulse is detected. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK VEHICLE SENSOR (OPERATION CHECK) |
Enter the "Vehicle Sensors" screen. Refer to check GPS & Vehicle Sensors in Operation Check (Click here).

While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.
- OK:
- The readings are almost equal.
|
|
||||
| OK | ||
| ||
| 2. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) |
Check the input waveform.

Remove the combination meter assembly with the connector(s) still connected.
Connect an oscilloscope to terminal E7-4 (+S) and body ground.
Turn the engine switch on (IG).
Turn the wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
Item
Condition
Measurement terminal
E7-4 (+S) - Body ground
Tool setting
5 V/DIV., 20 ms./DIV.
Vehicle condition
Driving at approx. 20 km/h (12 mph)
Text in Illustration *1
Component with harness connected
(Combination Meter Assembly)
- OK:
- The waveform is displayed as shown in the illustration.
- HINT:
- When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY - COMBINATION METER) |
Disconnect the F64 display and navigation module display connector.
Disconnect the E7 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F64-18 (SPD) - E7-4 (+S)
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
