2011-2013 Land Cruiser · Service Manual Power Source / Network

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE GENERATOR PULLEY

A156429E01
SST
09820-63011   (09820-06010, 09820-06021)

HINT:
SST 1-A and 1-B
09820-06010
SST 2
09820-06021

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured on the rotor shaft.

  1. A156430E01
    Mount SST 2 in a vise.

  1. Insert SST 1-A and 1-B into SST 2, and attach the pulley nut to SST 2.

  1. A156431E01
    To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove the generator from SST 2.

  1. A178030E01
    Turn SST 1-B, and remove SST 1-A and 1-B.

  1. Remove the pulley nut and pulley.


2. REMOVE GENERATOR REAR END COVER

  1. A178031E01
    Place the generator on the pulley.

  1. Remove the 3 nuts and end cover.

  1. A178032E01
    Remove the terminal insulator.


3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A178033E01
    Remove the 2 screws and brush holder.


4. REMOVE GENERATOR COIL ASSEMBLY

  1. A178034E01
    Remove the 4 bolts.

  1. A178035E01
    Using SST, remove the coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)


5. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A178036E01
    Remove the generator washer and rotor.


6. REPLACE GENERATOR DRIVE END FRAME BEARING

  1. A178040E01
    Remove the 4 screws and retainer plate.

  1. A163023E01
    Using SST and a hammer, tap out the bearing.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

  1. A163024E01
    Using SST and a press, press in a new bearing.
    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)

  1. A178041E01
    130 A Type and 150 A Type:
    Install the retainer plate with the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }

  1. 180 A Type:
    Install the retainer plate with the 4 screws.

    Torque:
    3.0 N*m{ 30 kgf*cm , 26 in.*lbf }

← REMOVAL (from Jan 2012)INSPECTION (from Sep 2011) →