After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3.
REMOVE CENTER BACK DOOR GARNISH
Detach the 5 clips and 4 claws, and remove the center back door garnish.
4.
REMOVE BACK DOOR SIDE GARNISH LH
Detach the 3 clips and 2 claws, and remove the back door side garnish LH.
5.
REMOVE BACK DOOR SIDE GARNISH RH
w/o Power Back Door:
HINT:
Use the same procedure described for the LH side.
w/ Power Back Door:
Detach the clip and 4 claws, and remove the back door side garnish RH.
6.
REMOVE ASSIST GRIP (for Face to Face Seat Type)
Remove the 2 screws and assist grip.
7.
REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER (for Face to Face Seat Type)
Using a screwdriver, detach the 4 claws and remove the No. 2 back door service hole cover.
Disconnect connector.
8.
REMOVE POWER BACK DOOR MAIN SWITCH (for Face to Face Seat Type)
Detach the 2 claws and remove the door opening switch sub-assembly.
9.
REMOVE BACK DOOR GARNISH
Using a screwdriver, detach the 14 clips and remove the back door garnish.
HINT:
Tape the screwdriver tip before use.
10.
REMOVE BACK DOOR GLASS CHANNEL LH (w/ Rear Spoiler)
Using a clip remover, remove the clip.
Remove the back door glass channel LH.
11.
REMOVE BACK DOOR GLASS CHANNEL RH (w/ Rear Spoiler)