2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

AVC-LAN Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers switch signals by the audio visual communication local area network.
If a short to +B or short to ground occurs in this AVC-LAN, the navigation system will not function normally as communication is stopped.

INSPECTION PROCEDURE

HINT:
The display and navigation module display is the master unit.


1. INSPECT DISPLAY AND NAVIGATION MODULE DISPLAY

  1. E194883E01
    Disconnect the F66 display and navigation module display connector.

  1. Disconnect the F60 display and navigation module display connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F66-1 (TX1+) - F66-2 (TX1-)
    Always
    60 to 80 Ω
    F60-9 (TX2+) - F60-10 (TX2-)
    Always
    60 to 80 Ω

Text in Illustration 
*1
Component without harness connected
(Display and Navigation Module Display)


NG
REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

HINT:
For details of the connectors, refer to Terminals of ECU (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.

    2. Check for an open or short in all AVC-LAN circuits.E194882E01

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.

    OK:
    Master unit returns to normal operation.



NG
REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)
OK

REPLACE MALFUNCTIONING PARTS


← Parking Brake Switch Circuit (Sep 2011 – Dec 2011)Reverse Signal Circuit (Sep 2011 – Dec 2011) →