2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This circuit is from the parking brake switch assembly to the display and navigation module display.

WIRING DIAGRAM

E150784E19

INSPECTION PROCEDURE


1. CHECK BRAKE WARNING LIGHT
  1. Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

    OK:
    The brake warning light operates as specified above.



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH - DISPLAY AND NAVIGATION MODULE DISPLAY)
  1. Disconnect the F64 display and navigation module display connector.

  1. Disconnect the E53 parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F64-17 (PKB) - E53-1
    Always
    Below 1 Ω
    F64-17 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. INSPECT PARKING BRAKE SWITCH ASSEMBLY

  1. E194874E01
    Disconnect the parking brake switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Switch body
    ON (When shaft is not pressed)
    Below 1 Ω
    1 - Switch body
    OFF (When shaft is pressed)
    10 kΩ or higher



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (PARKING BRAKE SWITCH - BODY GROUND)


← Illumination Circuit (Sep 2011 – Dec 2011)AVC-LAN Circuit (Sep 2011 – Dec 2011) →