2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

AVC-LAN Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

Each audio system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network.
If a short to +B or short to ground occurs in the AVC-LAN, the audio system will not function normally because communication is not possible.

WIRING DIAGRAM

C260263E01

INSPECTION PROCEDURE


1. INSPECT MULTI-MEDIA MODULE RECEIVER ASSEMBLY

  1. E238990E12
    Remove the multi-media module receiver assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    45 (TX3+) - 46 (TX3-)
    Always
    60 to 80 Ω



NG
REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)

HINT:
For details of the connectors, refer to Terminals of ECU (Click here).

  1. Referring to the following AVC-LAN wiring diagram, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.

    2. Check for an open or short in all AVC-LAN circuits.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. When disconnecting a slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the malfunctioning slave unit.

    OK:
    Master unit returns to normal operation.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE MALFUNCTIONING PARTS


← Sound Signal Circuit between Multi-media Interface ECU and Stereo Jack Adapter (Sep 2011 – Dec 2011)Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter (Sep 2011 – Dec 2011) →