Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The circuit is necessary for the Automatic Sound Levelizer (ASL) built into the stereo component amplifier assembly.Speed signals are received from the combination meter assembly and used for the ASL.
The ASL function automatically adjusts the sound volume in order to clear audio quality even when vehicle noise increases (as vehicle noise increases, the volume is turned up etc.).
- HINT:
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective system based on the pulse signal.
- If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
- A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective system based on the pulse signal.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMBINATION METER) |
Disconnect the F59 stereo component amplifier assembly connector and E7 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F59-2 (SPD) - E7-4 (+S)
Always
Below 1 Ω
F59-2 (SPD) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) |
Reconnect the E7 combination meter assembly connector.
Check the input waveform.

Connect an oscilloscope to terminal F59-2 (SPD) and body ground.
Turn the engine switch on (IG).
Turn a wheel slowly.
Check the signal waveform according to the condition(s) in the table below.

Item
Condition
Measurement terminal
F59-2 (SPD) - Body ground
Tool setting
5 V/DIV., 20 ms./DIV.
Vehicle condition
Driving at approx. 20 km/h (12 mph)
Text in Illustration *1
Front view of wire harness connector
(to Stereo Component Amplifier Assembly)
- OK:
- The waveform is displayed as shown in the illustration.
- HINT:
- When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
|
|
||||
| OK | ||
| ||
