2011-2013 Land Cruiser · Service Manual Suspension

C1794 Height Control OFF Switch Circuit (Test Mode DTC)

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This is the height control system main switch. When the height control switch is pushed, the height control OFF indicator light lights up and height control turns off.
The off condition of the height control will not be canceled until the height control switch is pushed again or the vehicle is driven.
DTC Code
Detection Condition
Trouble Area
C1794
The test mode procedure is performed.
  1. Harness or connector
  2. Suspension control switch (Height control OFF switch)
  3. Suspension control ECU

WIRING DIAGRAM

C177227E08

INSPECTION PROCEDURE

NOTICE:
  1. Before performing troubleshooting, inspect the connectors of related circuits.
  2. If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).


1. INSPECT SUSPENSION CONTROL SWITCH (HEIGHT CONTROL OFF SWITCH)
  1. Remove the suspension control switch (Click here).

  1. C261415E03
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (N) - 16 (E)
    Height control OFF switch is pushed.
    Below 1 Ω
    Height control OFF switch is not pushed.
    10 kΩ or higher



NG
REPLACE SUSPENSION CONTROL SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - SWITCH AND BODY GROUND)
C177225E06
  1. Disconnect the K34 ECU connector.

  1. Disconnect the V4 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K34-11 (TD) - V4-9 (N)
    Always
    Below 1 Ω
    K34-11 (TD) - Body ground
    Always
    10 kΩ or higher
    V4-16 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU (Click here)


← C1794 Height Control OFF Switch Circuit (Test Mode DTC) (Sep 2011 – Dec 2011)U0100 Lost Communication with ECM / PCM "A" (+ 7 more codes) (Sep 2011 – Dec 2011) →