2011-2013 Land Cruiser · Service Manual Suspension

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Also covers:

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The suspension control ECU receives signals from the ECM, four wheel drive control ECU, skid control ECU, yaw rate sensor, steering sensor, steering control ECU and main body ECU via CAN communication. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system first.
DTC Code
Detection Condition
Trouble Area
U0100
While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and ECM stops for 3 seconds or more.
  1. CAN communication system
  2. ECM
  3. Suspension control ECU
U0101
While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and ECM stops for 3 seconds or more.
  1. CAN communication system
  2. ECM
  3. Suspension control ECU
U0114
While driving at 30 km/h (19 mph), CAN communication between the suspension control ECU and four wheel drive control ECU stops for 3 seconds or more.
  1. CAN communication system
  2. Four wheel drive control ECU
  3. Suspension control ECU
U0122
CAN communication between the suspension control ECU and skid control ECU stops for 3 seconds or more.
  1. CAN communication system
  2. Skid control ECU
  3. Suspension control ECU
U0124
CAN communication between the suspension control ECU and yaw rate sensor stops for 3 seconds or more.
  1. CAN communication system
  2. Yaw rate sensor
  3. Suspension control ECU
U0126
CAN communication between the suspension control ECU and steering sensor stops for 3 seconds or more.
  1. CAN communication system
  2. Steering sensor
  3. Suspension control ECU
U0130
5 seconds after the engine switch is turned on (IG), CAN communication between the suspension control ECU and steering control ECU stops for 3 seconds or more.
  1. CAN communication system
  2. Steering control ECU
  3. Suspension control ECU
U0140
CAN communication between the suspension control ECU and main body ECU stops for 5 seconds or more.
  1. CAN communication system
  2. Main body ECU
  3. Suspension control ECU

INSPECTION PROCEDURE

NOTICE:
  1. Before performing troubleshooting, inspect the connectors of related circuits.
  2. If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).


1. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2. CHECK DTC
  1. Perform a road test.

  1. Check for DTCs.

    OK:
    DTC is not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD)
    B
    NG (for RHD)
    C



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1794 Height Control OFF Switch Circuit (Test Mode DTC) (from Jan 2012)U0100 Lost Communication with ECM / PCM "A" (+ 7 more codes) (from Jan 2012) →