2011-2013 Land Cruiser · Service Manual Suspension

TEST MODE PROCEDURE

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


TEST MODE PROCEDURE

HINT:
  1. When entering the test mode, the suspension control ECU stores all the test mode DTCs first. After completing the test mode for each check item, the test mode DTCs that are determined to be normal by the suspension control ECU will be cleared. The test mode DTCs for other check items may not be cleared when only a certain signal is inspected.
  2. When the test mode returns back to the normal mode, all the test mode DTCs will be cleared.

  1. Turn the engine switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the engine switch on (IG) and the tester on.

  4. Enter the following menus: Chassis / AHC / Utility / Signal Check.

  5. Read the test mode DTCs by following the prompts on the tester screen.

  6. After completing the test mode, disconnect the tester and turn the engine switch off.


TEST MODE DTC CHART
If a trouble code is output during the test mode DTC check, check the circuit listed for that code. For details of each code, refer to the "See page" for the respective DTC code in the chart.

HINT:
When entering test mode, the suspension control ECU outputs all the test mode DTCs. If the clear conditions for a test mode DTC are met, it is cleared.

DTC Code
Detection Item
Trouble Area
Clear Condition
See page
C1791
Damping force control switch circuit malfunction
  1. Harness or connector
  2. Suspension control switch
  3. Suspension control ECU
When each position (COMF/NORMAL/SPORT) of the damping force control switch is detected.
Click here
C1792
Height control switch circuit malfunction
  1. Harness or connector
  2. Suspension control switch
  3. Suspension control ECU
When the height control switch up and down operation is detected.
Click here
C1794
Height control off switch circuit malfunction
  1. Harness or connector
  2. Suspension control switch
  3. Suspension control ECU
When the signal of the height control OFF switch is detected.
Click here
C1796
Front acceleration sensor RH circuit malfunction
  1. Front acceleration sensor RH
  2. Harness or connector
  3. Suspension control ECU
On a level surface, the G sensor input is +/-1.96 m/s2 for 1 second.
Click here
C1797
Front acceleration sensor LH circuit malfunction
  1. Front acceleration sensor LH
  2. Harness or connector
  3. Suspension control ECU
C1798
Rear acceleration sensor circuit malfunction
Suspension control ECU (houses rear acceleration sensor )
← INITIALIZATION (from Jan 2012)TEST MODE PROCEDURE (from Jan 2012) →