C1718 Pressure Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit is used for sending the data to detect the pressure output from the pump. The abnormality of the fluid pressure is judged by the ECU.| DTC Code |
Detecting Condition |
Trouble Area |
| C1718 |
When one of the following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Before performing troubleshooting, inspect the connectors of related circuits.
- If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).
- Before performing troubleshooting, inspect the connectors of related circuits.
| 1. CHECK HARNESS AND CONNECTOR (PRESSURE SENSOR - SUSPENSION CONTROL ECU) |
- NOTICE:
- When inspecting the wire harness between the suspension control ECU and pressure sensor, it is difficult to determine the malfunctioning area if there is a sensor power supply malfunction. Therefore, disconnect the connectors for the pressure sensor, the acceleration sensors (front RH, front LH) and fluid temperature sensor on the ECU side.
Disconnect the i2 pressure sensor connector.
Disconnect the K34 and K35 ECU connectors.


Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
K35-10 (SPB) - i2-1 (SHB)
Always
Below 1 Ω
K35-19 (SPG) - i2-3 (SHG)
Always
Below 1 Ω
K35-20 (PACC) - i2-2 (PACC)
Always
Below 1 Ω
K35-10 (SPB) - Body ground
Always
10 kΩ or higher
K35-19 (SPG) - Body ground
Always
10 kΩ or higher
K35-20 (PACC) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK SUSPENSION CONTROL ECU |
![]() ![]() |
Connect the K34 and K35 suspension control ECU connectors.
Disconnect the i2 pressure sensor connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
i2-1 (SHB) - i2-3 (SHG)
Engine switch on (IG)
4.75 to 5.25 V
|
|
||||
| OK | |
| 3. CHECK PRESSURE SENSOR |
Connect the K34 and K35 suspension control ECU connectors.
Connect the i2 pressure sensor connector.
Start the engine and push the up button of the height control switch to activate height control.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
K35-20 (PACC) - K35-19 (SPG)
While height control is operating.
1.48 to 2.54 V
|
|
||||
| OK | ||
| ||

