2011-2013 Land Cruiser · Service Manual Brake

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


DTC CHECK / CLEAR (SST CHECK WIRE)

  1. C166029E04
    DTC check

    1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to ON.

    3. Read the DTCs from the ABS warning light on the combination meter.

      HINT:
      1. If no DTC is output, inspect the TC and CG terminal circuit and the ABS warning light circuit.
        Trouble Area
        See Procedure
        TC and CG terminal circuit
        Click here
        ABS warning light circuit
        Click here or Click here
      2. If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is output first.

    4. As examples, the illustration below shows the blinking patterns of the normal system code and DTC 11 and 21.
      F100113E08

    5. Refer to the Diagnostic Trouble Code Chart (Click here) for DTC information.

    6. After completing the check, turn the ignition switch off and remove SST from the DLC3.

  2. DTC clear

    1. C166029E04
      Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
      SST
      09843-18040  

    2. Turn the ignition switch to ON.

    3. C162683
      Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    4. Check that the ABS warning light outputs a normal system code.

    5. Remove SST from the terminals of the DLC3.

      HINT:
      Clearing the DTCs cannot be performed by disconnecting the cable from the negative (-) battery terminal or removing the ECU-IG NO. 2 fuse.


DTC CHECK / CLEAR (INTELLIGENT TESTER)
  1. DTC check

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Chassis / ABS/VSC/TRC / DTC.

    5. Read the DTCs by following the directions on the intelligent tester screen.

  2. DTC clear

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Chassis / ABS/VSC/TRC / DTC.

    5. Clear the DTCs by following the directions on the intelligent tester screen.


END OF DTC CHECK / CLEAR
  1. Turn the ignition switch to ON.

  2. Check that the ABS warning light goes off within approximately 3 seconds.

← DIAGNOSIS SYSTEM (from Jan 2012)DTC CHECK / CLEAR (from Jan 2012) →