C1242/42 IG2 Power Source Circuit
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
If there is a problem with the master cylinder solenoid (skid control ECU) power supply circuit, the skid control ECU stores DTCs and prohibits operation under the fail-safe function.If the voltage supplied to the IG2 terminal is within the DTC detection range due to malfunctions in components such as the battery and alternator circuit, this DTC is stored.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1242/42 |
The vehicle speed is 3 km/h (1.9 mph) or more and the voltage of the ECU IG2 terminal remains below 6.5 V for more than 7 seconds. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. INSPECT BATTERY |
Check the battery voltage.
- Standard voltage:
- 11 to 14 V
Result
Proceed to
OK
A
NG
for 2UZ-FE
B
for 1VD-FTV
C
for 3UR-FE
D
|
|
||||
|
|
||||
|
|
||||
| A | |
| 2. INSPECT IGN FUSE |
Remove the IGN fuse from the engine room relay block.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
IGN fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT SKID CONTROL ECU (IG2 TERMINAL) |
Install the IGN fuse.
Disconnect the A25 skid control ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A25-1 (IG2) - Body ground
Ignition switch ON
11 to 14 V
|
|
||||
| OK | |
| 4. INSPECT SKID CONTROL ECU (GND TERMINAL) |
Disconnect the A24 and A25 skid control ECU connectors.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A24-1 (GND1) - Body ground
Always
Below 1 Ω
A24-32 (GND2) - Body ground
Always
Below 1 Ω
A25-4 (GND3) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 5. RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTC is output (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
Result Result
Proceed to
DTC is not output
A
DTC is output
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | ||
| ||
