2011-2013 Land Cruiser · Service Manual Brake

C1257/57 Power Supply Drive Circuit

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.
DTC Code
DTC Detection Condition
Trouble Area
C1257/57
There is an open in the motor system circuit (motor input circuit).
Hydraulic brake booster pump motor circuit

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK PUMP MOTOR OPERATION
  1. Turn the ignition switch off.

  1. Disconnect the A24 skid control ECU connector.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to ON.

  1. Check pump motor operation.

    OK:
    Pump motor normally operates.

    Result
    Proceed to
    OK
    A
    NG
    for LHD
    B
    for RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A


2. RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Reconnect the A24 skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    for LHD
    B
    for RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1257 Power Supply Drive Circuit (from Jan 2012)C1268 Transfer L4 Position Switch Circuit (from Jan 2012) →