C1268/68 Transfer "L4" Position Switch Circuit
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
After confirming that the transfer is in the L4 position, CRAWL will be activated according to the vehicle conditions.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1268/68 |
The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and the intelligent tester on.
Select "Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.
- OK:
- "Bus Check" indicates no malfunctions in CAN communication.
Result Result
Proceed to
"Bus Check" indicates no malfunctions in CAN communication.
A
"Bus Check" indicates malfunctions in CAN communication.
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and the intelligent tester on.
Check for DTCs (for LHD: Click here/ for RHD: Click here).
Result Result
Proceed to
CAN system DTC is not output
A
CAN system DTC is output
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | ||
| ||
