2011-2013 Land Cruiser · Service Manual Brake

C1282 Center Differential Lock Position Switch

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

DTC C1282 is stored only in test mode.
DTC Code
DTC Detection Condition
Trouble Area
C1282
Stored during test mode.
  1. Harness or connector
  2. Transfer system

WIRING DIAGRAM

C215183E13

INSPECTION PROCEDURE


1. CHECK DTC
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC C1340 is not output
    A
    DTC C1340 is output
    B



B
GO TO DTC C1340 (Click here)
A


2. CHECK TEST MODE DTC
  1. Switch the vehicle to test mode, perform the center differential lock signal check, and then check that the Test Mode (Signal Check) DTC C1282 is cleared (Click here).

    Result 
    Result
    Proceed to
    Test Mode DTC C1282 is cleared
    A
    Test Mode DTC C1282 is not cleared
    B



B
Go to step 3
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)

3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - 4 WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR)
  1. Disconnect the A24 skid control ECU (master cylinder solenoid) connector.

  1. Disconnect the A27 4 wheel drive control ECU connector.

  1. Disconnect the C37 transfer shift actuator assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-27 (EXI) - A27-14 (P1)
    Always
    Below 1 Ω
    A24-27 (EXI) - C37-3 (CDL)
    Always
    Below 1 Ω
    A24-27 (EXI) - Body ground
    Always
    10 kΩ or higher
    C37-7 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)


← C1268/68 Transfer "L4" Position Switch Circuit (Sep 2011 – Dec 2011)C1289 VGRS Control System Malfunction (from Jan 2012) →