2011-2013 Land Cruiser · Service Manual Brake

C1268/68 Transfer "L4" Position Switch Circuit

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
C1268/68
The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU.
  1. Center differential lock detection switch
  2. Center differential lock detection switch circuit
  3. Four wheel drive control ECU
  4. ECM

WIRING DIAGRAM

C173285E02

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and the intelligent tester on.

  1. Select "Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.

    Result 
    Result
    Proceed to
    "Bus Check" indicates no malfunctions in CAN communication
    A
    "Bus Check" indicates malfunctions in CAN communication
    LHD
    B
    RHD
    C

    OK:
    "Bus Check" indicates no malfunctions in CAN communication.



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and the intelligent tester on.

  1. Check for DTCs (LHD: Click here/RHD: Click here).

    Result 
    Result
    Proceed to
    CAN system DTC is not output
    A
    CAN system DTC is output
    LHD
    B
    RHD
    C



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

GO TO TRANSFER SYSTEM (INSPECTION) (Click here)


← C1268 Transfer L4 Position Switch Circuit (from Jan 2012)C1282 Center Differential Lock Position Switch (from Jan 2012) →