C1268 Transfer L4 Position Switch Circuit
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1268 |
The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via CAN communication for 2 seconds or more. |
|
INSPECTION PROCEDURE
- NOTICE:
- After replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. INSPECT TRANSFER L4 SHIFT |
Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.
- OK:
- There are no problems with the transfer system.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Shift the transfer to L4, drive the vehicle, and then check for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output (for LHD)
B
DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
