VSC OFF Indicator Light does not Come ON
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
Refer to VSC OFF Indicator Light Remains ON (Click here).WIRING DIAGRAM
Refer to VSC OFF Indicator Light Remains ON (Click here).INSPECTION PROCEDURE
- NOTICE:
- After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).
| 1. CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
Select "CAN Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.
- OK:
- "CAN Bus Check" indicates no malfunctions in CAN communication.
Result Result
Proceed to
OK
A
NG (for LHD)
B
NG (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and the GTS on.
Check for DTCs (for LHD: Click here, for RHD: Click here).
Result Result
Proceed to
CAN system DTC is not output
A
CAN system DTC is output (for LHD)
B
CAN system DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 3. READ VALUE USING GTS (TRC/VSC OFF MODE) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
TRC/VSC Off Mode
TRC/VSC off mode/ Normal, TRC OFF, Unknown or VSC OFF
Normal: Normal mode
TRC OFF: TRC OFF mode
VSC OFF: VSC OFF mode
-
Check that the mode display changes according to VSC OFF switch operation.
- OK:
- Display changes according to switch operation.
|
|
||||
| OK | ||
| ||
| 4. INSPECT VSC OFF SWITCH |
Remove the VSC OFF switch (Click here).
Inspect the VSC OFF switch (Click here).
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Turn the ignition switch off.
Disconnect the A24 skid control ECU (master cylinder solenoid) connector.
Disconnect the G13 VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A24-9 (CSW) - G13-6
Always
Below 1 Ω
A24-9 (CSW) - Body ground
Always
10 kΩ or higher
G13-3 - Body ground
Always
Below 1 Ω
Result Result
Proceed to
NG
A
OK (for LHD)
B
OK (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
