Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
DESCRIPTION
The SLIP indicator light blinks during VSC, A-TRC, CRAWL or hill-start assist control operation. When the system fails, the SLIP indicator light comes on to warn the driver (Click here).
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. INSPECT IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
Check the skid control ECU connector connection.
OK:
The connector is securely connected.
NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK
2. INSPECT BATTERY
Check the battery voltage.
Standard voltage:
11 to 14 V
Result
Result
Proceed to
OK
A
NG
for 2UZ-FE
B
for 1VD-FTV
C
for 3UR-FE
D
B
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) (Click here)
C
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) (Click here)
D
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) (Click here)
A
3. CHECK CAN COMMUNICATION LINE
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and the intelligent tester on.
Select "Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.
Result
Result
Proceed to
"Bus Check" indicates no malfunctions in CAN communication
A
"Bus Check" indicates malfunctions in CAN communication
for LHD
B
for RHD
C
OK:
"Bus Check" indicates no malfunctions in CAN communication.
B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A
4. CHECK DTC (CAN COMMUNICATION SYSTEM)
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and the intelligent tester on.