2011-2013 Land Cruiser · Service Manual Vehicle Interior

Air Conditioning Control Panel Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit consists of the air conditioning control assembly and air conditioning amplifier assembly. When the air conditioning control assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate when the air conditioning control assembly is operated.

WIRING DIAGRAM

E157369E47

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and relays for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - AIR CONDITIONING CONTROL)
  1. Disconnect the E81 air conditioning amplifier assembly connector.

  1. Disconnect the F10 air conditioning control assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E81-37 (LIN1) - F10-5 (LIN1)
    Always
    Below 1 Ω
    F10-5 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - BATTERY AND BODY GROUND)

  1. E234126E01
    Disconnect the F10 air conditioning control assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F10-7 (IG+) - F10-1 (GND)
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F10-1 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Air Conditioning Control Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE AIR CONDITIONING CONTROL ASSEMBLY
  1. Temporarily replace the air conditioning control assembly with a new or normally functioning one (Click here).


NEXT


4. CHECK AIR CONDITIONING CONTROL ASSEMBLY
  1. Operate the air conditioning control assembly to check that it functions properly.

    OK:
    Air conditioning control assembly operates normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

END (AIR CONDITIONING CONTROL ASSEMBLY IS FAULTY)


← U0100 Lost Communication with ECM / PCM "A" (+ U0142, U0155) (from Jan 2012)Air Conditioning Control Panel Circuit (from Jan 2012) →