2011-2013 Land Cruiser · Service Manual Power Source / Network

4WD Control ECU Communication Stop Mode

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

Detection Item
DTC Detection Condition
Trouble Area
4WD Control ECU Communication Stop Mode
  1. "Four Wheel Drive Control" is not displayed on "Bus Check".
  2. "4WD Control ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside 4WD control ECU
  2. 4WD control ECU branch wire or connector
  3. 4WD control ECU

HINT:
For vehicle with 4WD only.


WIRING DIAGRAM

E211915E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (4WD CONTROL ECU BRANCH WIRE)

  1. E211916E01
    Disconnect the A27 4WD control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A27-19 (CAN+) - A27-20 (CAN-)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to 4WD Control ECU)



NG
REPAIR OR REPLACE 4WD CONTROL ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (4WD CONTROL ECU - BATTERY AND BODY GROUND)

  1. E211917E01
    Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the A28 4WD control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A28-4 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A28-3 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*1
Front view of wire harness connector
(to 4WD Control ECU)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE 4WD CONTROL ECU (Click here)


← Display and Navigation Assembly Communication Stop Mode (Sep 2011 – Dec 2011)4WD Control ECU Communication Stop Mode (from Jan 2012) →