2011-2013 Land Cruiser · Service Manual Power Source / Network

Display and Navigation Assembly Communication Stop Mode

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

Detection Item
Symptom
Trouble Area
Display and Navigation Assembly Communication Stop Mode
  1. "Display and Navigation (AVN)" is not displayed on "Bus Check".
  1. "Display and Navigation Assembly Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside display and navigation module display
  2. Display and navigation module display branch wire or connector
  3. Display and navigation module display

HINT:
For vehicles with the navigation system only.


WIRING DIAGRAM

C175531E13

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (DISPLAY AND NAVIGATION MODULE DISPLAY BRANCH WIRE)

  1. E191884E10
    Disconnect the F64 display and navigation module display connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    F64-21 (CANH) - F64-22 (CANL)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Display and Navigation Module Display)



NG
REPAIR OR REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY - BATTERY AND BODY GROUND)

  1. E191884E09
    Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F64-10 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F64-1 (+B1) - Body ground
    Always
    11 to 14 V
    F64-2 (ACC) - Body ground
    Ignition switch ACC
    11 to 14 V
    F64-3 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*1
Front view of wire harness connector
(to Display and Navigation Module Display)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (Click here)


← AFS ECU Communication Stop Mode (from Jan 2012)4WD Control ECU Communication Stop Mode (Sep 2011 – Dec 2011) →