Vehicle Speed Signal Circuit
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
The headlight leveling ECU receives the vehicle speed signal from the combination meter.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the headlight leveling ECU, initialization of the ECU is necessary (Click here).
| 1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Using the intelligent tester, read the Data List (Click here).
HL Auto Leveling (w/ Static Headlight Auto Leveling) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Vehicle Speed
Vehicle speed / 0 to 327.67 km/h
Actual vehicle speed
-
- OK:
- The display is as specified in the normal condition column.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY) |
Disconnect the E7 combination meter connector.
Disconnect the E109 headlight leveling ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E7-4 (+S) - E109-16 (SPDR)
Always
Below 1 Ω
E7-4 (+S) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK COMBINATION METER ASSEMBLY |
w/ Multi-information Display:
Remove the combination meter with its connector still connected (Click here).

w/o Multi-information Display:
Remove the combination meter with its connector still connected (Click here).
Connect an oscilloscope to the combination meter connector.
Check the waveform.
Measurement Condition Item
Content
Terminal No. (Symbol)
E7-4 (+S) - Body ground
Tool setting
5 V/DIV., 20 ms./DIV.
Condition
Vehicle is driven at approximately 20 km/h (12 mph)
- OK:
- Waveform is as shown in the illustration.
Text in Illustration *a
Component with harness connected
(Combination Meter Assembly)
- HINT:
- When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
|
|
||||
| OK | ||
| ||
