2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Headlight Dimmer Switch Circuit

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

The turn signal flasher receives a turn signal light information signal from the headlight dimmer switch.

WIRING DIAGRAM

E156579E01

INSPECTION PROCEDURE


1. INSPECT HEADLIGHT DIMMER SWITCH (TURN SIGNAL SWITCH)

  1. E155807E02
    Remove the headlight dimmer switch (Click here).

  1. for LH Side:Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    13 (TR) - 12 (EL)
    Turn signal switch right turn
    Below 1 Ω
    Turn signal switch off
    10 kΩ or higher
    15 (TL) - 12 (EL)
    Turn signal switch left turn
    Below 1 Ω
    Turn signal switch off
    10 kΩ or higher

  1. E159508E01
    for RH Side:Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    16 (TR) - 19 (EL)
    Turn signal switch right turn
    Below 1 Ω
    Turn signal switch off
    10 kΩ or higher
    18 (TL) - 19 (EL)
    Turn signal switch left turn
    Below 1 Ω
    Turn signal switch off
    10 kΩ or higher



NG
REPLACE HEADLIGHT DIMMER SWITCH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH - TURN SIGNAL FLASHER AND BODY GROUND)

  1. E156580E02
    Disconnect the E14 switch connector.

  1. Disconnect the E19 relay connector.

  1. for LH Side:Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E14-13 (TR) - E19-6 (ER)
    Always
    Below 1 Ω
    E14-15 (TL) - E19-5 (EL)
    E14-12 (EL) - Body ground
    E14-13 (TR) - Body ground
    Always
    10 kΩ or higher
    E14-15 (TL) - Body ground

  1. E156580E01
    for RH Side:Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E14-16 (TR) - E19-6 (ER)
    Always
    Below 1 Ω
    E14-18 (TL) - E19-5 (EL)
    E14-19 (EL) - Body ground
    E14-16 (TR) - Body ground
    Always
    10 kΩ or higher
    E14-18 (TL) - Body ground

    Result 
    Result
    Proceed to
    OK (for LHD)
    A
    OK (for RHD)
    B
    NG
    C



B
REPLACE TURN SIGNAL FLASHER ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE TURN SIGNAL FLASHER ASSEMBLY (Click here)


← Vehicle Speed Signal Circuit (from Jan 2012)Headlight (HI-BEAM) Circuit (Sep 2011 – Dec 2011) →