2011-2013 Land Cruiser · Service Manual Vehicle Interior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  2. *: Use the intelligent tester.
  3. If the ignition switch cannot be turned to ON, communication with the intelligent tester can be performed by connecting the intelligent tester to the vehicle and turning a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

      HINT:
      A simple method to determine whether the battery is depleted is to operate the horn.

    NEXT

    3.CRANK ENGINE FOR MORE THAN 10 SECONDS
      NEXT

      4.CHECK FOR DTC*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Based on the DTCs output above, proceed to each diagnostic procedure.

        Result 
        Result
        Proceed to
        DTC is not output
        A
        SFI system DTC is output (for 1GR-FE)
        B
        ECD system DTC is output (for 1VD-FTV)
        C
        Engine immobiliser system DTC is output
        D


      B.

      C.

      D.
      A

      5.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      A

      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List / Active Test (Click here).

      2. Terminals of ECU (Click here).

      NEXT

      7.ADJUST, REPAIR OR REPLACE
        NEXT

        8.CHECK FOR DTC*
        1. Clear the DTCs (Click here).

        2. Check for DTCs (Click here).

          HINT:
          Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure (Click here).

          Result 
          Result
          Proceed to
          DTC is not output
          A
          Engine immobiliser system DTC is output
          B


        B.
        A

        ← SYSTEM DESCRIPTION (from Sep 2011)HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2012) →